How do i hook up my above ground pool filter, connecting the pool return:
Set the disk and hose on top of the skimmer. Connect the other end of this hose to the inlet port on the side of your pool.
How Do You Change the Sand in a Pool Filter?
Connect the return hose. This page Center Drain Installation shows as illustration of how a center drain gets plumbed into an above ground pool. We have a Pentair sand filter that we just cleaned out and replaced the sand with new.
It has two valve shut offs and do we have to go through the heater? They should all have valves so that the suction can be regulated.
Once the winter is over, and the outdoor temperatures begin to rise, it is time to reopen the pool for the summer. Heaters and chlorinators should be installed on the return line. We are not using the heater or the auto chlorinator as they are both broken. After you have connected both ends you will want to tighten the hose clamps thoroughly.
You should hear this click into place. For that reason, you need to clean your above-ground pool with a pool vacuum at least once a week.
Video of the Day
Winterization also requires you to disconnect the hoses for the pool, pump and filter. Hook the other end of the hose to the front of the pump. Trying to remember where each of the three hoses attach to your filter, pool and pump can quickly spell disaster if you mix up the connections.
Leaving them out is not a problem.
Simply click here to return to Above Ground Pool Filters. The hose coming out of the filter should go straight to the pool return, unless an inline chlorinator, or heater is being used.
Turn on the above-ground pool pump. Pool Filter Hookup We have a Hayward cartridge filter and a main drain for our 24 foot above ground pool.